3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [jyers]

5 questions
4
votes
1 answer

Inconsistent Z-height on Ender 3 V2 print bed

I have an Ender 3V2 running a custom version of Jyers Marlin, and using a CR Touch as a Z-stop, and with a heated glass print bed. This is my first printer, and it mostly prints fine except when printing near the edges where some imperfections with…
jasooney23
  • 71
  • 1
  • 7
3
votes
1 answer

Browsing and printing print files (G-code) stored in OctoPrint from printer's screen

I'm using an Ender 3 v2 with Jyers firmware. I'm looking for a firmware / OctoPrint plugin which allows browsing G-codes stored in my OctoPrint storage and starting them directly from my printer's screen like it's stored on SD card. I would like to…
Piotr Smarzyński
  • 33
  • 2
3
votes
2 answers

Extruder stops printing before finishing first layer (Ender 3 v2 w/BIQU H2)

Let me preface this with me being quite a newbie to 3D printing, however, I am an engineer and coder, so tinkering with stuff like this is quite the norm for me. Don't be afraid to be too technical, knowledge is power! I recently purchased a new…
user995551
  • 238
  • 1
  • 3
  • 7
3
votes
1 answer

What would cause magic smoke with a BLTouch installed?

I decided to purchase a BLTouch for my Ender 3 V2. I did all the physical installation of the BLTouch at the same time as adding LED lighting. I plugged in the power to test the lighting (BLTouch was not plugged in yet) and everything came on fine…
agarza
  • 1,734
  • 2
  • 16
  • 33
1
vote
0 answers

Creality Ender 3 V2 Printed objects incorrect dimensions

I have had a Creality Ender 3 v2 with a 4.2.2 motherboard for about 2 years. It's a company-owned machine but I got it just about when Covid hit so it has only been used at home. It worked OK at first. I used it a good bit. Then I got a Prusa and…
Chuck
  • 11
  • 3