So I have this exact problem as in this thread: BLTouch calibrated, nozzle still dives into the bed
But I don't see a clear solution to that question, or I don't understand. After correct calibration of the BLTouch, it is homing correct with the correct nozzle distance to bed, but when printing it hits the bed. It's supposed to be plug & play ;).
Here are the details of my setup:
- Ender 5 with 4.2.7 silent board
- TH3D Marlin 2.0 firmware (flashed it and then an EEPROM reset)
- Cura slicer 4.10.0
- BLTouch V3 from Trianglelab mounted on 5-pin, but end-stop on the micro-switch end-stop 2-pin. Also enabled this in Marlin. Offset -41, -11, 0
Could someone please help me? But be aware I'm quite new in programming stuff.
