I got a NETGEAR FVS338 ProSafe VPN Firewall Router. I planned to use it as Interior Router that seating in back of my Sagemcom Gateway F@st 5366 TN-A.
I'm running quite few business application servers in my home office. The Sagemcom networks configured as:
- Local IPv4 Address 10.0.1.1
- Local Subnet Mask 255.255.0.0
- Local Ethernet Mac address xx:xx:xx:xx:xx:xx
- Public IPv4 Address 58.105.xxx.xxx
- Public Subnet Mask 255.255.240.0
- Default Gateway 58.105.160.2
- Primary DNS Server 198.142.152.164
- Secondary DNS Server 198.142.152.165
When FVS338 plugged into sagemcom network, configured it as:
From the above image you can see, I had created a different network (10.0.2.0/24) for Netgear FVS338 LAN under Sagemcom network (10.0.1.0/24). Wan side (Broadband configure) has IP address 10.0.1.92 seating sagemcom networks as Netgear gateway IP.
I tried to add the router to my MacOS Host in Sagemcom network to access subnet 10.0.2.0/24. by run [sudo route -n add -net 10.0.2.0/24 10.0.1.92]
Then, I set up NetGear FVS338 [Security] -> [Firewall] -> [Attack Checks] -> [WAN Security Checks] by ticking [Respond to Ping on Internet Ports].
Then, I ping 10.0.1.92 and 10.0.2.1 success
Then, When I tried to configure [LAN WAN Rules] by adding an [Inbound Services] to expose host 10.0.2.203 that seat in NetGear FVS3338 network.
I tried to ping the exposed host under Netgear FVS338, but I never get it through.
I log in to Netgear FVS338 from the command line by USING CLI, and ping 10.0.2.203 from Netgear FVS338 self, the ping works fine, but I ping 10.0.2.203 from the WAN side (Sagemcom network), I never get it through.
Any idea?
