Questions tagged [anycubic-kobra]
5 questions
1
vote
1 answer
Uneven layers - Anycubic Kobra 1
I have this case uneven defect on print when using Anycubic Kobra, it occurs from the first layer. I use 0.6 nozzle and all the default features.
Here're the actions that I already tried:
Built-in auto probing function
=> No improvement
Manual…
DrPortgas
- 51
- 6
1
vote
2 answers
How do I prevent PETG from stringing and clumping up?
My PETG prints keep clumping up and stringing. The print is otherwise fine, but there are so many imperfections because of this. It looks like the clumping comes from the infill.
I tried replacing the nozzle with a hardened steel one and fiddling…
brain56
- 147
- 8
0
votes
2 answers
3D printing of moving toys
I just started diving into the world of 3D printing and I am faced with the problem of the last layer. There are platforms like islands, as if there are high layers at the end, even steps. I tried in Anycubic slicer with the settings (according to…
Александр
- 3
- 4
0
votes
1 answer
Anycubic Kobra Go bed leveling
I can’t figure out what the issue is. The far side of the bed (Y-axis) print won’t adhere because the extruder is too far off while on the near side is too thin. I have tried all the troubleshooting tips I can find online and nothing worked. Even as…
Jeff Weber
- 9
- 1
0
votes
2 answers
Anycubic Kobra freezing mid print
About 30 minutes into a print, the printer stopped printing. It froze in one place and when I realised that it had gone awry, there was a large blob of PETG stuck to the nozzle, which I have since removed. The screen was unresponsive at the print…
Lithanium
- 49
- 1
- 7