1

Having started with an Ender 3, it just seemed natural to me that the heatbreak should not be load-bearing; Creality's stock hotend has 2 bolts holding the heat block to the heat sink, which of course waste some heating power and increase the cooling needed to avoid heat creep, but serve the important purpose of keeping the nozzle position rigid relative to the carriage and making it so you don't bend or snap the heatbreak when changing nozzles.

Looking at hotends (especially all-metal ones) for a possible future printer build, I'm surprised to see that many (most?) don't have this property, and have the heatbreak playing a load-bearing role. This seems really undesirable. Only the Mosquito makes a point of doing this right, and supposedly has a patent on this or related design decisions. Is that really the case? Are there basic all-metal hotends that are designed to avoid making the heatbreak load-bearing that don't cost $150?

R.. GitHub STOP HELPING ICE
  • 13,474
  • 5
  • 43
  • 79

2 Answers2

2

The drop-in replacement all metal hotends for the Ender 3 that I've looked at seem to have the two screws -- though I've read/heard opinions that these are intended to be removed after assembly, these are common Mk. 8 type hot ends, but with 2 mm bore through the entire heat break instead of 4 mm. That seems to be the only modification (other than not anodizing the aluminum heat sink).

While the brand name units of this type run approximately 65 USD at retail, they're available from Chinese vendors for under 10 USD plus a few dollars shipping, if you don't mind waiting a few weeks instead of a couple days to receive your part -- and if they aren't from the same production but sold without extensive vendor support, they're very close physical copies, according to review videos I've seen.

It's also possible to replace just the heat break for similar cost, either in stainless or titanium, with a 2 mm bore unit; this would obviously preserve whatever additional mounting hardware exists on/between your original heat block and heat sink.

BTW, if they aren't already, replacing the screws with stainless will significantly reduce heat loss through the screws -- stainless is a much poorer conductor of heat than common steels used with plated screws.

Zeiss Ikon
  • 1,870
  • 2
  • 11
  • 31
1

You ask in general, not specifically for Ender, so since you mention the Mosquito, which has a characteristic shape and a size, the obvious alternative which doesn't cost that much is the Phaetus Dragon.

It copies the idea of the Mosquito, but it is repackaged in a shape and size fully equivalent to standard v6 hotends so it's a drop-in replacement for any v6 hotend. You don't have one, but in general...

Footnote: Slice Engineering got the patent in US, but not in Europe and China, yet. Also, in Europe their idea apparently was found as not original. Who knows...

FarO
  • 4,610
  • 21
  • 39