1

I had a failed print lastnight and a glob of pla surrounded the hotend. After heating it up and removing the glob the extruder does not release any significant material. I checked with OctoPrint and the extruder stepper does push filament without the hot end on.

After fully heating the hot end I was able to remove the nozzle.

I then pushed the previously melted PLA out of the tube and heater. It was discolored in the heater. I then tried to put the nozzle back on and pull the old PLA out of the nozzle but no success there.

Should the nozzle be left in acetone for a few days before trying again or how should this be dealt with. The nozzle appears to be blocked.

0scar
  • 37,708
  • 12
  • 68
  • 156
Kendrick
  • 179
  • 8

1 Answers1

5

If the hotend is okay, consider yourself lucky and consider the nozzle a loss. Aside from specialty items like ruby tip ones, nozzles are a consumable anyway. Even if you can clean it out well enough to get it working again, it's unlikely to extrude as well as a new clean nozzle. Acetone is probably not going to help; PLA does not dissolve in acetone, and while the pigments/additives might be affected by it enough to weaken and deform PLA in a way that could get it to detach, what's clogging your nozzle is likely burnt/carbonized PLA that's unlikely to be removable by anything that won't also destroy the brass.

If you don't already have replacements on hand, get yourself a pack of 10-20 for $10 or so and be ready to replace when needed. You can also go for a mixed-size pack if you want to try printing fine details with a smaller (0.1-0.3 mm) nozzle or super-fast but rough with a large (0.8-1.0 mm) nozzle.

R.. GitHub STOP HELPING ICE
  • 13,474
  • 5
  • 43
  • 79