1

I got a new CR-10S 3D printer (I received it at Christmas). It has been printing just fine until yesterday, I was doing a print and it randomly paused, it did not restart on its own, I had to restart the print, then the item finished just fine. I am printing today, a very small item, the printer now stopped 3 times. How can I fix this, or do I need to return it?

0scar
  • 37,708
  • 12
  • 68
  • 156
Lori Banister
  • 11
  • 1
  • 2

3 Answers3

2

The cr10s has a filament run-out sensor. If the microswitch doesn't function properly, or you have issues with the wiring, the print pauses.

Razwer
  • 51
  • 2
0

It would be great if you can write what the printer says when it stops.

I suggest you try printing other small objects. If that also stops then the printer itself has a problem. But if the printer prints other objects without stopping, then the one you want to print has bad gcode files. You also need to make sure to keep it up-to-date Cura. It would also be great if you can update your printer firmware. But other than that, problems could be heat problem, power problem, and other stuff; it would be great again if you can write the problem that says on the printer as it stops...

D DD
  • 11
  • 1
0

Just an off chance: you might somehow have pause instructions being set into the G-code without your being aware.

0scar
  • 37,708
  • 12
  • 68
  • 156
Craig
  • 1