Questions tagged [crtouch]
5 questions
1
vote
1 answer
How to lower the nozzle height by 0.2 mm?
Here are the details of my printer:
Creality Ender 5
STM32F103RET6
CR Touch: - Model: ALT04 - CX: 231120001838
Mainboard: v4.2.7
I’m trying to adjust the nozzle height on my Creality Ender 5 (4.2.7 + CR Touch) to -0.2 mm, so that it’s closer to…
viikktor_
- 11
- 2
1
vote
2 answers
How much variation can auto bed leveling compensate for?
I just upgraded an original CR-10 with the CRTouch bed leveling sensor and upgraded the firmware from stock to Marlin. In the CURA slicer, I added a preamble to every print to perform bed leveling. The bed leveling is running a 5 by 5 (25 point)…
st2000
- 171
- 7
1
vote
3 answers
What do I need to configure to get Marlin to run an Ender 3 Pro with CR Touch?
I have an Ender 3 Pro, board version 4.2.2, and a CR Touch with 5 pin connector. I also removed the z-axis endstop connector at the endstop.
I've been building and flashing Marlin 2.1.2.2, but I haven't found a configuration that makes the CRTouch…
ttshaw1
- 31
- 5
1
vote
2 answers
What's the accuracy and reliability difference between BLTouch, CRTouch and 3D touch?
What are the differences between the bed leveling probes BLTouch, CRTouch and 3DTouch in terms of reliability and accuracy?
Is there some kind of benchmark available? Also, how often should the plastic 'probes' in the BL and 3D touch be replaced? As…
Bob Ortiz
- 1,255
- 1
- 10
- 44
1
vote
1 answer
Is the BFPTouch interchangable with the BLTouch for mriscoc firmware without custom changes to Marlin?
I have two Creality Ender 3 V2 printers with a version 4.2.2 board. One printer has the official CRTouch, and one is nearly original without a probe. I found a similar product, a DIY project called BFPTouch, and I have almost all the parts needed to…
Bob Ortiz
- 1,255
- 1
- 10
- 44