2

Something changed on my Ender 5 Pro. I do not know what. Only that even after re-leveling the bed several times it won't lay down a stable first layer unless I go into the tune menu and manually raise the Z level slightly to bring the bed closer to the nozzle.

How do I change, and then save, the printer's settings so that this slight rise is applied to all future prints?

I presume that this is the offset value?

I'm running stock firmware.

Finding out what changed and why is a question for later.

Aaargh Zombies
  • 2,320
  • 2
  • 20
  • 43

1 Answers1

1

I know this is old, but did you check that the little bolt/thumbscrew at the back of the printer didn't get tightened/loosened? It's the one that makes contact with the switch to stop the bed once it reaches max height, in between the threaded vertical rod and smooth vertical rod on the right that the bed "travels" on. That was my issue, took me forever to figure out why my prints were all trying to start a few mm in the air.

CrumblyMuffins
  • 11
  • 1